Circle Cutter-

Punch 905

Thrilling Thursday

Today's project is a 3-Dimensional Peacock.
I've included the instructions to make this glitzy bit of paper fancy.
Kreaxions tools used on this project are the Circle Cutter and Punch #905.

Pck14 (1000x666)



4 inch circle (green)

Punch #905

Pck1 (900x900)
Place center mark of the protractor at the edge of the circle.

Mark at 50, 70, 90, 110, and 130 degrees; draw lines.

Pck2 (898x900)

Center punch on each line.

Trim areas between punch marks to resemble feathers.

Pck3 (798x800)


4 inch circle (blue)

Punch #905

Pck5 (698x700)

Divide circle into 8 sections, center punch on each line.

Pck6 (900x737)

Trim resulting "doily" in half and then lay against body

to get the correct angle for the wings.

Pck8 (800x800)

Roll body/wings on a vitamin bottle to get curved shape.


10 strips of each color (1"x 6") with ends punched.

Pck10 (700x700)

Roll each strip length wise on a pencil to get curved shape.

Pck11 (800x742)

Attach tail feathers in staggered rows.

Neck and Head


1.25 inch circle (green)

4 inch circle (blue)

2 scalloped corners (blue)

Pck4 (897x900)
Cut 1" off the circle, wrap into cone shape, pinch the cone to make it narrow.

Pck9 (900x900)

Match scalloped punched corners so that colored sides are out. Fold small circle in half and adhere scallopes inside. Attach circle to small opening of the cone, trimming to achieve desired angle.

Cut slit in neck, 1 inch from the large opening, for tail placement.

Pck13 (1200x800)

Check my blog Scrappin' Chaos for peacocks in other color schemes.

Scrap On!


4 thoughts on “Thrilling Thursday

  1. Lisa M.


  2. Joan

    This project is just stunning!

  3. GinniG

    OMG Charity!!!!! This totally ROCKS! Awesome use of the punch and the circle cutter!!!

  4. Bev Code

    stunning project

Leave a Reply

Your email address will not be published. Required fields are marked *